Product Info
Literature

Overview

Universal hot surface ignition module replaces multiple field installed hot surface ignition modules supplied by Resideo, White-Rodgers, Robertshaw and Johnson. Uses a 120 VAC igniter. Includes cross reference, instructions, and accessories for easy replacement.

Features

Replaces over 800 White-Rodgers, Robertshaw and Resideo hot surface ignition models.
For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
S8910U 3000 Series has LED status indicator and microammeter ports for easy trouble shooting
For local (single rod) or remote (dual rod) rectification type flame sensing.
Contains easy-to-use cross reference and instructions plus the accessories required to replace the existing hot surface ignition module.
Provides one or three ignition trials (four-second or seven-second trials) per call for heat.
Field selectable number of ignition trials and trial time based on unit being replaced.
Igniter warm up time: 7 (12 seconds second and third trial), 17 (27 seconds second and third trial), 34, or 45 seconds

Product Specifications

Dimensions (in.): 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long
Dimensions (mm): 133 mm high x 103 mm wide x 49 mm deep
Item Type: Product
Electrical Ratings: 24 Vac
Frequency: 60 Hz
Approvals, Canadian Standards Association: Design Certified
Tradeline Value: Tradeline
Flame Failure Response Time (sec): 1.5 sec.
PrePurge: 32 seconds
Ambient Temperature Range (C): -40 C to +79 C
Ambient Temperature Range (F): -40 F to +175 F
Ignition System Type: Direct Hot Surface Ignition
Ignition Sequence: The number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial.
Typical Gas Control: VR8205, VR8305
Type of Gas: Natural or LP
Flame Sense: Single Rod or Two Rods
Ignition Source: Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)
Ignition Trials To Lockout: 1 or 3
Lockout Timing: 4 sec. or 7 sec.
Ignition Trial Time (sec): 4 sec. or 7 sec.
Maximum Valve Load @ 24 Vac (Amps): 2A
Typical Ignition Hardware: Norton 201, Norton 271, Q354
Between Trial Time (sec): (2) 96 sec.- 3 trial mode only